Civic-EG.com Forum 3.3.1

- Thu Jun 10, 2010 11:42 am #199645 Hi guys and gals i am new here and just wanted to post up some pics of my project

Mods so far.
*Energy Suspension Bushings kit
*Tein lowering springs
*Blox LCA's
*Beaks lower tie bar
*Buddy Club front and rear camber kits
*Password JDM side markers,smoked corners
*8K HID kit
*15" Exel Rims with 195/50/15 Kumho tires
*2.5" catback exhaust
*JDM B16a
*ATS Clutch-type LSD
*H.O.P center console
*Grant GT Racing Wheel
*Sunpro Oil Pressure Guage
*A/C delete

how it looked the day i got it









after etch-priming the trunk black



Wrapped the door panel inserts in Bride seat material



Bought a jdm B16a swap for it, came with ATS Racing LSD



Ebay catback exhaust, For NOW!



Bought these rims for 100 bux..



Traded them for these....



Interior as of now 6\10\2010



Exterior





Feedback would be appreciated, thanks

Shot of my bay


traded my friend rocker covers, this one is from an integra GSR

I am not much of a photographer, but I like this pic





newly painted heat shield and plug wire cover



Password JDM Sidemarkers



My replacement fenders I worked on in auto body



Little teaser of the paint job i am planning, at this link

http://www.paintwithpearl.com/youtubecolorchange.htm

UPDATE 6/11/2010



FEEDBACK PLEASE!

Last edited by Tristanw10 on Fri Jun 11, 2010 10:59 am, edited 3 times in total.

- Thu Jun 10, 2010 1:07 pm #199656 looking good.

92 civic cx sold!!
horizon gray 94 LX-A wrecked :/
white 92 civic Si (traded)
primered 94 teg sold
92 civic DX sold!!
93 red EX coupe parted out!
93 LS400 Midnight indigo sold!
92 civic LX sold!!
90 240sx sold!
93 faded black EX coupe

- Thu Jun 10, 2010 3:39 pm #199694 looks like a good project how did you remove those inner door panels? and where did you get bride material? haha

- Thu Jun 10, 2010 4:12 pm #199703 Thanks for the feedback guys, the door panels were a pain in the a** man, I used a drill bit to drill out the melted rivets on the back then pried it apart with a flat blade screw driver. I bought the material from an ebay store called togue factory. pics of the engine bay coming soon....