Page 1 of 1
d16z6 turbo do i need to change my map sensor
Posted:
Wed Jun 06, 2012 10:01 pmby motoxash
im planning my boosted d16z6 sedan im ordering hbeam rods vitara pistons but the cars guna be daily driver so im only looking for bout 9 psi would there be any point in getting a 3 bar map sensor or would the standard map sensor cope with 9 - 10 psi ?
Posted:
Wed Jun 06, 2012 10:09 pmby dbrooks
I'd just upgrade. I have a Motorola 2.5 bar map sensor I'm selling. $30 shipped
Posted:
Thu Jun 07, 2012 2:27 amby teal_dx
The oem map will throw a cel around 11 psi. I've got the Motorola 2.5 bar map on my setup and it's great... Will give you a little room to turn up the boost down the road.
Posted:
Thu Jun 07, 2012 3:32 pmby d-mon
oem map sensor can only measure up to +10.x psi.
if your going to boost 10psi or more, you need to upgrade and re-tune with then new map sensor.
keep in mind you will want to have a boost cut in your tune in case of surging or your w/g fails.
thanx guys
Posted:
Fri Jun 08, 2012 7:42 amby motoxash
i will upgrade and i may have that one pay day ill contact then
