Civic EG

If you're going turbo, you're going to need bigger injectors for lots of boost.



I used DSM 450cc and they did not fit quite right... they were bigger and did not go in as far:



this prevented the fuel rail from going on all the way





There's a couple ways to remedy this...

You can either dremel out the hole in the rubber insulator to help the injector sink down a little further. Like grinding out the hole in a donut to make it bigger.

Or you can cut the insulator in half, like you would cut a bagel.


I'm gonna go eat breakfast now

or if you have enough space to still thread on a nut. then you just put a spacer where the gap is... thats what ive always done for taller injectors..

hey im doing this to mine... but mine were already made for putting in... nice pix

awww... wish i knew this when i was doing turbo... i bored my injector rings bigger to fit took me hella long to do all 4 hahaha