Catch can
Posted: Thu Dec 29, 2011 1:57 pmHey I was wondering if a catch can be modded to have a beather fit on it .
Page 1 of 1
Posted: Thu Dec 29, 2011 1:57 pmPosted: Thu Dec 29, 2011 2:42 pmYes, that's what I did to mine. I bought a cheap one on ebay and drilled a hole on the top, screwed on a hollow fitting and then got one of those tiny valve cover breathers from autozone.
Posted: Thu Dec 29, 2011 2:46 pmYou can buy them with a breather fitted but they double in price do what teal said and DIY
Posted: Thu Dec 29, 2011 3:18 pmok sweet teal i got one from auto zone and was not sure about drilling in it omg sweet guys thanks hey teal thanks alot man 
can you show me pic of it or if not its ook
can you show me pic of it or if not its ookPosted: Thu Dec 29, 2011 3:23 pm
Posted: Thu Dec 29, 2011 3:31 pmso just drill small hole in the top of it and add small tube ? and thats it
Posted: Thu Dec 29, 2011 3:33 pmkc12305 wrote:so just drill small hole in the top of it and add small tube ? and thats it
hallow fitting, with a barbed nipple to slide the filter on it.
Posted: Thu Dec 29, 2011 3:55 pmpretty tight!
Posted: Thu Dec 29, 2011 3:58 pmso its basicly like the fitting on the waste gate right cause im going to the store later im just trying to make sure i get the right thing
Posted: Thu Dec 29, 2011 4:08 pmI used a threaded compressor fitting I had sitting around. Get your catch can & breather, measure twice, drill once and you'll be ok.
Posted: Thu Dec 29, 2011 4:10 pmok very nice hey stank you get my email
Posted: Sun Jan 01, 2012 9:10 pmok here it is done and done thanks again teal for the advice
