HAFIL0_EG's Project EG Roll-Cam cover fresh paint p.16

Post YOUR Hatchback here
 Reply
User avatar

By HAFIL0_EG
- Tue Nov 06, 2012 1:15 pm #319293 A lil something something came in the mail today :P

Image
Image

not much else to report with the hatch build up atm apart from give the B16 a decent clean with degreaser n old toothbrush over this weekend
User avatar

By HAFIL0_EG
- Mon Nov 12, 2012 1:18 pm #319779 not much done lately, only managed to install the skunk2 cam seal over the weekend and degrese the motor. And tonight after work i began to remove the 0bd1 loom out of the EG6 half cut, so dash is out and heater boxes it tempts me to take out and leave out the heat n a/c out of the hatch n go ultra light but still want a lil comfort on hot days and cold nights

cam cover off
Image
getting stuck into it
Image
removing the old cam seal
Image
not the best pic but new skunk2 cam seal in its place
Image

will have pics of the half cut wiring being stripped out in the next couple of days
User avatar

By HAFIL0_EG
- Tue Nov 13, 2012 1:04 pm #319866 thanks bigJOE

stripped out the 0bd1 loom out of the half cut after work tonight and discovered that i have to do some cut n shut work with LH door loom as they cut it when they removed the door :/ otherwise a fairly straight forward removal.

stripping out the half cut
Image

loom removed from behind the dash
Image

0bd1 loom out of the half cut, still need to remove the RH side for spares
Image

further stripping of the half cut will happen over the rest of this week
User avatar

By HAFIL0_EG
- Sat Nov 24, 2012 7:54 pm #320818 not much going on with the hatch lately due to Christmas only being round the corner, but did finally got round to have the cam cover sand blasted and painted up :)

here's the cam cover thats seen better daysImage

oil filler cap and spark plug lead brackets removed ready for the sand blasters
Image

back from the sand blasters, only cost me a 6 pack of Jack Daniels n Cola = AU$30
Image

all masked up and ready for paint
Image

VHT wrinkle plus paint freshly added
Image

end product :)
Image

cam cover fitted back up to the motor
Image
Image

By onibakagaijin
- Sun Nov 25, 2012 12:50 am #320834 Very nice with the cover. Slow but steady wins the race and your build looks good :thumb:
User avatar

By kapow
- Sun Nov 25, 2012 3:51 am #320839 Valve cover looks mint!
User avatar

By HAFIL0_EG
- Thu Nov 29, 2012 4:56 pm #321173 Thanks guys, got some time off of work up my sleeve and decided that a semi wire tuck is next on the cards. I only wish to tuck the headlight wiring so far, I will also paint up the factory eg6 strut brace in red crinkle just to freshen things up a bit as well as make good use of the can of red paint.

Ill post up pics of further progress as things get done.
 Reply
Return to Your Ride - Hatchback