Dash Seats, Steering Wheels etc... If it's inside your Civic then it's in here.
User avatar
By ceelx
#334544
Low for life wrote:Seeing if someone has done a conversion from manual windows to power windows from a 95 civic to a 93 hatch?


i did it myself on my ferio ( 4dr ) and was super easy :wink: first of all you have to check if you alread have cables on your under dashboard wirings. if not you will have to add 4 cables i guess :roll:
By DirtyEye
#334615 I did it before on my past EG hatch. You need the power window motors, switches, relay, door panels and wiring.

I have a spare set of the door wiring left which I can give you for small $$$.
By cjw_89
#335378 It it possible to make your own harness from a pillars in. I have regulators,switches,door wiring,door lock module,door lock switch, I need door panel inserts(power model) cab harness and the actual mechanisms that allow your door to lock/unlock.
By ej0470114
#335563 http://www.google.com/url?q=http%3A%2F% ... 6qd5yK9X9A

If u follow this write up ull be fine ............ It takes a lil while to get the parts and figure out the diagrams but its worth it ......... u can also pin in jdm power folding mirrors just follow the diagrams .......... and if ur serious when ur looking for parts at the junk yard u might as well do this too

http://www.google.com/url?q=http%3A%2F% ... O73jd5Jqiw

it's really not hard just takes some elbo grease and patience ........... Quick tip when it comes to the door locks all u need is the actuator not the whole mechanism it's the same in both power and non power locks

@cjw_89. Yes it's possible just follow the diagram it woildent be as clean as oem but it would make it Easyer instead of clawing behind the heater core to get it
User avatar
By chrono404
#335566 You can get aftermarket power window kits as well. Given that OEM stuff is 18 to 21 years old it might not be a bad idea.