Civic-EG.com Forum 3.3.1

- Mon Feb 18, 2013 8:41 pm #326737
Thinking about buying a set of these Prelude seats for my hatch...obviously have to modify the rails. how much work would it take?

- Mon Feb 18, 2013 10:16 pm #326751 IIRC, you swap the rail that unbolts with the EG rail. The other is riveted in.

2007 Honda Civic Si

- Tue Feb 19, 2013 3:03 am #326765 Above commment is right. Swap the one rail that unbolts with one from your original seat and enjoy.

It belongs in a museum!

- Tue Feb 19, 2013 4:12 am #326770 it is right, but the two studs on the eg half of the rail dont line up with the holes on the prelude part of the rail. line up the last hole(the one that is an actually bolt and not a stud welded on the rail) on both pieces, and then mark and drill the prelude rail to fit the studs on the eg rail. after that it bolts into the car perfectly.

i actually just did this about 3 weeks ago. love these seats.

My never-ending EG8 project.
Daily Driver '98 OBW

- Sun Feb 24, 2013 2:55 am #327174 Juls I ran into that. I marked an drilled and bolted in. My Cx seats were super torn and shitty. These look and feel a million times better