Civic EG

Posted: **Sat Feb 16, 2008 7:51 pm**

okay ive got all the parts needed for my tranny now, clutch fork, spring, throw out bearing, new slave cylinder, anyone know exactly how this shit goes together? :thumb:

Posted: **Sat Feb 16, 2008 7:57 pm**

ios the throw out bearing supposed to click onto the fork? i dont get how this is gonna work

Posted: **Sat Feb 16, 2008 8:34 pm**

do you have a haynes or chiltons manual yet? If not, it is the best $10 you'll ever spend :thumb:

I don't have any pics of this for you

Posted: **Sat Feb 16, 2008 8:39 pm**

http://www.hondaautomotiveparts.com/aut ... CH+RELEASE

http://www.hondaautomotiveparts.com/aut ... R+CYLINDER

here's a couple diagrams that may help, pics aren't very good though

Posted: **Sat Feb 16, 2008 9:01 pm**

do i even have the right throw out bearing? cause judging by those diagrams and the manual i got it doesnt seem so

http://cgi.ebay.com/ebaymotors/ws/eBayI ... 87744&rd=1

i bought this one

Posted: **Sat Feb 16, 2008 9:15 pm**

yea so i called up autozone and asked for my specific throw out bearing and ima go @ 4:30 to check it out, ima take mine and compare, if not, then im out 15 bucks on this one, but oh well. im sure i could re sell it. LOL :thumb:

Posted: **Sat Feb 16, 2008 9:32 pm**

The throw out bearings little forks slide over the end of the shift fork. If I recall correctly there is dimples in the shift fork for the throw out bearing to ride in.

Page 12-12 of the 92-95 Civic Helms Manual.

Posted: **Sat Feb 16, 2008 9:33 pm**

oh and hey teal, on your radiator, what did u do to cap the auto tranny fluid lines?

Posted: **Sat Feb 16, 2008 9:35 pm**

chrono404 wrote:The throw out bearings little forks slide over the end of the shift fork. If I recall correctly there is dimples in the shift fork for the throw out bearing to ride in.

Page 12-12 of the 92-95 Civic Helms Manual.

yea i got that manual, i downloaded it off d-series.org

and its quite obvious i got the wrong bearing, so i threw this one up on craigslist or unless another member is interested in purchasing it.

15 bucks. lol never used ha

thanks tho chrono, ima go pick up my new bearing, this just set me back a couple hours :lol:

Posted: **Sat Feb 16, 2008 9:43 pm**

just put some rubber caps on the end of the lines or leave them open. either way it doesn't really matter :thumb:

Posted: **Sat Feb 16, 2008 9:58 pm**

oh okay, good shit, well starting @ 4:30, im going to be finishing this swap that ive been doing for over a month now HA

took some pics of my car in the garage

http://civic-eg.com/viewtopic.php?p=42553#42553

update :thumb:

Posted: **Sat Feb 16, 2008 10:34 pm**

and for future refrence for anyone else

the one on the left is the on ei got, thats for a cable series tranny, and the one on the right is one im getting for a Hydraulic Tranny.

dont make the same mistake i did!!!

Civic EG

okay lil stuck on the clutch release fork

okay lil stuck on the clutch release fork