Civic-EG.com Forum 3.3.1

- Tue May 06, 2014 12:39 pm #345339 Hi everyone, I have scanned through all the post's in the transmission forum and have not been able to find this info.

I am looking for the correct size on the FILL BOLT and DRAIN BOLT on the B series SI 2000 civic trany.

What I know is = Fill bolt 20mm x ?
Drain bolt 14mm x 1.5

I need to confirm for a special build that I am trying to work on for my EG CIVIC.
Thank you all for you help in advance.

- Tue May 06, 2014 2:52 pm #345350 Do you just need the thread size and pitch?

1992 Honda Civic SIR-S

- Tue May 06, 2014 5:03 pm #345357 I am trying to confirm thread size and pitch.
The fill bolt I know is a 20mm , but I do not know the pitch.
The drain is a 14mm with 1.5 pitch . just need to confirm this one.

Thanks for the help.

- Wed May 07, 2014 7:44 pm #345414 Ill take a thread pitch gauge home tonight and verify them for you

1992 Honda Civic SIR-S

- Wed May 07, 2014 7:51 pm #345416 Thank you so MUCH !!!!!!!
THANK YOU THANK YOU ....

- Thu May 08, 2014 8:08 pm #345440 Any Info ? Thanks Again.

- Fri May 09, 2014 3:02 pm #345455 been uber busy. I'm sorry

1992 Honda Civic SIR-S

- Fri May 09, 2014 5:00 pm #345460 No problem, Thank you for the help.

- Mon May 19, 2014 3:46 pm #345738 Good afternoon HeikDiesel,

Any info ?
Thanks for the help.

- Mon May 19, 2014 6:41 pm #345739 Promise promise I'll get it done for you tonight. Been out of town since Wednesday for a bachelor party but I'll make sure I'll measure it for you tonight

1992 Honda Civic SIR-S

- Mon May 19, 2014 7:09 pm #345740 Those are the best parties. Hope you guys to lots of pictures for evidence. Or did you guys look like the Hangover movies ?
LOL
Thanks for the help. If your ever in miami Fl,
Look me up.

- Tue May 20, 2014 2:51 am #345745 Alright driv here ya go

fill= m19x1.5
drain= m14x1.5

1992 Honda Civic SIR-S

- Tue May 20, 2014 12:17 pm #345748 Thank you Heik,

I have some home work to do know.
I'll get back to with the findings on that trani cooler.
Have a great day

- Tue May 20, 2014 4:14 pm #345758 You know after I measured mine I went on google and searched for that fill plug and there was a guy on honda-tech that was unable to find that m19x1.5 to a AN fitting so he drilled and tapped the top of the case and ran an oil cooler that way. His car was sponsored by mfactory and they may have a pre-made oil cooler kit already.

1992 Honda Civic SIR-S

- Tue May 20, 2014 6:56 pm #345762 In the beginning of my creation of this cooler, I found the post on that guy with the prelude. I have also called Mfactory in cali, they stop the production on the product. I am trying to put something together on paper before buying all of the components.
I'll keep you posted.
Thanks again.