Civic EG

Hey guys I'm getting ready to swap out the front hub assembly on my 92 vx with a gsr swap and I was wondering which hub bearing it takes. If any of you know I would appreciate it. I'm getting sick of hearing this womp womp womp noise constantly haha.

bradleyg wrote:Hey guys I'm getting ready to swap out the front hub assembly on my 92 vx with a gsr swap and I was wondering which hub bearing it takes. If any of you know I would appreciate it. I'm getting sick of hearing this womp womp womp noise constantly haha.

Are you swapping the entire spindle assembly? If so you want to get the bearing that goes along with that which should be the same for all Integra models.

The bearing are different sizes so u will have to use the gsr bearing. And I think there is a difference in size if they came from a abs or non abs..Not sure hope someone else can chime in and help. Here are these two links with pretty good info on brakes.

http://honda-tech.com/showthread.php?p=45884943

http://honda-tech.com/showthread.php?t=3044628

^^ just did a search at napa and orielly auto parts and both show the same part number for the front wheel bearing between the LS and the GS-R the only difference in the ABS and non is the centric ring that is on the axle, and the sensor that is bolted to the spindle.

Thanks for the help guys. I'm going to get the wheel bearing for the gsr non-abs and hope that's the right one. If not I'll have to take it back and get the other one haha
I just wasn't sure if I use the civic bearing or the gsr bearing.

Glad we could help.