What size crush washers on fuel inlet to fuel rail? fixed
Posted: Sun Aug 02, 2015 7:05 pm
by FlopUrDonk
What size crush washers do I need to fit on either side of the banjo bolt on the fuel inlet to the fuel rail. Dropped them in the engine and they have disappeared. Just been notified I can't use my other ride tomorrow and need to get to work. Lol.
Posted: Sun Aug 02, 2015 7:06 pm
by FlopUrDonk
Any help will be awesome.
Posted: Sun Aug 02, 2015 7:46 pm
by FlopUrDonk
Nevermind. This is one of them right?
Posted: Sun Aug 02, 2015 9:55 pm
by FlopUrDonk
-6 crush washer. 12mm. Nobody carries them except the dealership. Looks like I'm calling I. Sick. Lol.
Posted: Mon Aug 03, 2015 7:05 pm
by HeikDiesel
-6 and 12mm shouldn't be the same size. 12.7mm in a 1/2" and -6 is 3/8" so just a forewarning on that information. As far as a crush washer I know I've used copper ones from my work. I could figure out a part number if you're really that curious.
Posted: Mon Aug 03, 2015 11:40 pm
by FlopUrDonk
I ended up finding the other one. One of the washer is pretty unique. Thanks though man.