Page 1 of 1
what to use to fill buttom rubber engine mounts
Posted:
Mon Aug 23, 2010 9:23 pmby TENGOKU25
so yer what could i use to fill them as thay are prity mashed up after engine swap ? . some 1 said to use urethane adhesive ? just wounding what elss will be strong to use ?
Posted:
Mon Aug 23, 2010 9:38 pmby jred
jus use the urethane dude,
Posted:
Mon Aug 23, 2010 9:42 pmby TENGOKU25
hmm but what sort as i keep finding all sorts
..... might sound dum but would gum gum work good ?
Posted:
Mon Aug 23, 2010 10:02 pmby {ikon}EM1
Just buy new mounts... Inovative mounts r preety cheap and they come in different Finnishs
Posted:
Mon Aug 23, 2010 10:22 pmby TENGOKU25
i just looked thay ant cheap
lol ill stick with just filling them
Posted:
Mon Aug 23, 2010 11:48 pmby jred
Posted:
Wed Aug 25, 2010 6:32 pmby suspendedHatch
I prefer to put motor mount inserts into the two front lower mounts and then buy a new rear mount on ebay and leave the inserts out. Vibration is just a bit worse than stock but not nearly as bad as when you put the inserts in the rear mount.
You feel the improvement the most when shifting.
Posted:
Thu Sep 02, 2010 5:05 pmby Wikedeye
Use 3m window weld. You can get it at autozone. I used it on all my mounts when I did my swap and it works great. It took 1 1/2 tubes for all of my mounts so one tube should work for you.