Civic EG

ok im new to this site so be gentle and im sure that there is a post for this already but im in iraq and my internet sucks and i dont have the patience to search with internet being gay. ok here is the question im looking to put stage 2 cam shafts, rods, 81mm forged pistons, after market valve spring and retainers, cam gears, and buddy club valves, and i intend to put a turbo in the car, now my question is what kind of fuel system set up should i use and what parts should i get keep in mind this is all going in to a b16a1 also i havent bought the parts yet just pricing and mapping out the build before i go there

you'll need a Walbro 255 fuel pump, 440cc++ injectors, fuel regulator, and you'll wanna put in a fresh fuel filter.


walbro 255 is around $100
*new injectors are gonna be $200+
regulator setup is around $75 i think
filter about $20

JUICE wrote:you'll need a Walbro 255 fuel pump, 440cc++ injectors, fuel regulator, and you'll wanna put in a fresh fuel filter.


walbro 255 is around $100
*new injectors are gonna be $200+
regulator setup is around $75 i think
filter about $20

my wong thred my bad

thanks juice for the info now to get the parts

ok i went and looked up some of those parts the fuel pump do i want the one with high pressure or or just the standard 255 pump and for the the injectors do i want peak and hold or do i want a saturated type

not too sure on the pump. with the injectors, you want ones that are high-impedance.

awesome thanks again

ok where can i get the fuel filters that im going to need and would i need any electronics for this

any auto parts store will carry a filter. their inexpensive, easy to install, and require no new "electronics".