Technical Topics specific to the 2 dr. coupe body - NOT where you post pics/build specs of your car.
By Macster
#79980 no clue on the hood. you have to do a mix and match for the seats the bottom part has to come out of a 4door dc2 and the back has to come out of a 2door dc2 if you use both 2door pieces there will be a gad between the two. and either way the seat backs will not lock in place because the integra is a hatch and the locks are on the side not in the middle like the coupe has.
User avatar
By asianrob
#79981 shouldnt he use the 4door upper and lower?.. i would imagine the 2door one's would leave a gap on the sides?
User avatar
By Greasedmonkey
#79983
DC4rob wrote:shouldnt he use the 4door upper and lower?.. i would imagine the 2door one's would leave a gap on the sides?


thats what he needs.
User avatar
By Grat
#79987 sand and buff your hood.....u will most likely have to reclear it though
By Macster
#80145 oh my bad i did the swap into a hatch that needs a mix coupe prolly is a full 4 door set my bad.