Technical Topics specific to the 2 dr. coupe body - NOT where you post pics/build specs of your car.
User avatar
By curtismcghee12
#161496 Just recently i realized the drivers side of my trunk lid is alittle high.

i tried taking the trunk off and bending the hinge and that didnt work
might have been to gentle with it :cry:
any ideas?

or reasons it ended up that way cause it hasnt always been like that :?
User avatar
By ikon
#161497 maybe someone tried to break in.... idk. any sign of forced entry.
User avatar
By curtismcghee12
#161506 didnt look likie it at all

someone suggested i may have closed it and the hinge hit.

seems likely
User avatar
By ikon
#161517 is all the rubber seated right?
User avatar
By Baby Carlos
#161519 trunk delete = weight reduction

SHEDDIN POUNDS FTMFWiiiiNNnnNNNnnnNn!@!!!1!!!1!111!!!!!1!!1!234%$4^46$%%
User avatar
By BurqueB16
#161612 yeah mine does this too and ive noticed it on a few other coupes as well, im not really sure how to fix it. but if you figure it out post a diy :thumb:
User avatar
By Classiccarsrule85
#161616 could it be due to something in your trun hitting the hinge? fold your rear seat down and take a gander when its closed maybe you maysee something then.....
User avatar
By curtismcghee12
#161619 instead of useing an element like carbon fiber ima use just a plain O2 trunk.

may have a water issue
:wink:


yes I checked the rubber and that didnt seem to be the problem unfortunantly.

and i shall give it a shot and puttin the seat down and taking a look

ill get back to you after
User avatar
By hatchie
#161625 there's crossabars underneath connecting the two hinges to my the trunk lid lift open when you push it up

in auto collsion we had a car that had this problem and it turned out to be one of those bar was kinked from someone putting huge things in their trunk (perhaps a bike :hehe: ) lol jking but seriously the bar was kinked and it pushed the trunk open a little on one side from the force
User avatar
By curtismcghee12
#162198 ill try it and let everyone know so we can get rid of this issue