Civic EG

I was looking through the forums to see if I could find one about this, but I'm looking to put the black DA seats in my hatch? are they direct bolt in or can i take the brackets of my eg seats and put them on the DA seats?

any help would be appreciated, thanks

if im correct 3 of the 4 bolt up, one is bolt sticks out farther then should.

what do you mean 3 of the 4 bolts?

that 3 bolts match up 1 doesn't

That sucks. I had wondered this myself. I have 94 Integra seats, but DA seats look better.

I had them in my EG for a while. I believe it was the outer rear bolt on both seats that didn't match up.
The only time you'll notice it is when you try and get someone in the backseat or when you try and move the seat back and forth.

Very comfy and lovely seats.

The rails won't swap either?

my del sol seats are that way too. I've heard gsr seats have the same problem as well?

I think I have DA seats in my hatch. Only two bolts will fit, then you knotch a little chunk off the rail with a grinder and you can put a bolt through the missing part. They have adjustable lumbar and adjustable side bolsters. FTW

DA seats wont fit unless you mod the EG brackets.... same as the EF seats. the Del sol is the one that 3 bolts line up and etc.. i know because i had to JB weld some rails to some CRX Si seats in one of my cars before.

4th gen prelude seats are also a nice.. they hug you like a bear and you feel like you have 2x the room lol