Page 1 of 1
b18c1 swap
Posted:
Thu Apr 10, 2008 11:51 amby rushvillejdmracing
hey guys i just found this forum i have a 92 civic hatch back cx and i just got my gsr swap obd1 can you guys just tell me off the top of your heads what i need to do i think i use the gsr throtle cable am i right and anything else that my come to mind thanks
Phil Anderson
Posted:
Thu Apr 10, 2008 12:06 pmby B18cDelSlo
what all did you get with the swap?
axles? ecu? how many miles are on it?
You might want to change out the clutch while you have the motor out. I added a fidanza 7lb flywheel as well.
Posted:
Thu Apr 10, 2008 6:11 pmby k0rean4life
you will need the following...
GSR longblock
B-series tranny
B-series axles
shift linkage
B-series rear t-bracket
GSR throttle cable
GSR driver mount
USDM alternator ( BIG GREEN PLUG)
ECU
Wiring Needed...
Knock sensor
Vtec soleniod
Vtec Pressure
Secondary Butterfly
IAB
O2 sensor
Recommended to replace...
Clutch kit
Resurface flywheel or replacement
timing belt
water pump
tensioner
spark plugs and wires
Cap and rotor
Fuel fitler
GSR fuel pump or 195 Walbro ( not a most but helps a lot )
Posted:
Thu Apr 10, 2008 6:18 pmby andy63
i just borrow this thread a little, i have a Honda civic Vei. I dont know what u calls it in Uk or USA but maybe VX, anyway it is a Vtec thats supose to run low fuel. Anyway, can i use that Vtec solenoid to a B18 engine??
Posted:
Thu Apr 10, 2008 6:23 pmby k0rean4life
andy63 wrote:i just borrow this thread a little, i have a Honda civic Vei. I dont know what u calls it in Uk or USA but maybe VX, anyway it is a Vtec thats supose to run low fuel. Anyway, can i use that Vtec solenoid to a B18 engine??
You should be able to, You can with the vx. What color is the wire?oh yea one more thing you most likely have a three wire IACV. You will need to convert that to a two wire. Check that and see if its 2 or 3.
Posted:
Fri Apr 11, 2008 12:20 amby RAKUN
this is a very good answer, i will take note for my gsr too
k0rean4life wrote:you will need the following...
GSR longblock
B-series tranny
B-series axles
shift linkage
B-series rear t-bracket
GSR throttle cable
GSR driver mount
USDM alternator ( BIG GREEN PLUG)
ECU
Wiring Needed...
Knock sensor
Vtec soleniod
Vtec Pressure
Secondary Butterfly
IAB
O2 sensor
Recommended to replace...
Clutch kit
Resurface flywheel or replacement
timing belt
water pump
tensioner
spark plugs and wires
Cap and rotor
Fuel fitler
GSR fuel pump or 195 Walbro ( not a most but helps a lot )