- Mon Jun 27, 2016 8:45 pm
#359394
Hi all, done a lot of reading but cannot seem to get a clear answer.
My project eg hatch is coming along nicely and hoping to have the h22 in there within the next few months.
I have installed a brand new fuel tank, new fuel low level sensor, new fuel sender unit with Walbro 255 pump.
I've ran 3 x an -6 stainless steel braided Teflon hoses from the front bulk head all the way to the tank. One for the fuel feed, one for the return and one to the 2 way valve for vapors.
Is this OK? Or will the pump struggle to keep pressure due to the increased hose internal diameter?
I'd appreciate your opinions on the matter, many thanks.
My project eg hatch is coming along nicely and hoping to have the h22 in there within the next few months.
I have installed a brand new fuel tank, new fuel low level sensor, new fuel sender unit with Walbro 255 pump.
I've ran 3 x an -6 stainless steel braided Teflon hoses from the front bulk head all the way to the tank. One for the fuel feed, one for the return and one to the 2 way valve for vapors.
Is this OK? Or will the pump struggle to keep pressure due to the increased hose internal diameter?
I'd appreciate your opinions on the matter, many thanks.