Page 1 of 1
Quarter Panel Window Weather Stripping.
Posted:
Wed Jan 16, 2008 1:54 amby indianguy89
Hey guys/gals, the car i've got is a 93 Si Hatch. Currently I dont have any weather stripping on my quarter panel windows. I got some from Honda the other day, and its near impossible to put it on while the window is there! This leads me to think that the window has to be removed to put on the weather stripping. Do you have to remove the window to put in the weather stripping, or have you guys put it in w/o removal of the quarterpanel window? Feedback is appriciated, Thanks!
Posted:
Wed Jan 16, 2008 2:43 amby teal_dx
I pulled mine off when I painted my car, and it was very hard to put it back on. I still cannot get one of the sides on perfectly. I started by the door and went all the way around stuffing little by little in at a time with a flat head screw driver. Bot dont use one with a sharp tip, dull will not tear the rubber. do about 6 inches and then do 6 inches on the opposite edge. this will prevent there from being a lot of extra slack when you get to the end.
Posted:
Wed Jan 16, 2008 2:38 pmby Graham
I just started at the bottom where it meets the door and worked my way around, i used some silicon lubricant stuff too, made it slide back in place a bit easier - dont really want to do it again though, my fingers were acheing afterwards
Posted:
Wed Jan 16, 2008 3:06 pmby teal_dx
doing it on a hot day when the rubber is softer could help too.
Posted:
Thu Jan 17, 2008 1:01 amby Greasedmonkey
The best, fastest and easiest way to do it is toooo....
Pay someone else that knows what they are doing to do it.
Posted:
Thu Jan 17, 2008 6:28 pmby indianguy89
^ Yeah true. But at the same time I'd like to know how to do it as well!
Posted:
Fri Jan 18, 2008 1:24 amby Greasedmonkey
watch him do it?
Posted:
Fri Jan 18, 2008 2:38 amby slm01
And I thought I was the only one missing that trim molding around the quarter windows. I need to get the molding, but I'm going to wait until the car gets painted.
Posted:
Fri Jan 18, 2008 6:21 pmby indianguy89
lol, I always thought that I was the only person missing the molding..
Posted:
Sat Jan 19, 2008 12:27 amby sqsi
I took mine off when the car was painted as well and the bodyshop said it was a pain to put back on, but it looks good.
Posted:
Sat Jan 19, 2008 10:45 amby yankee92vx
i am in the process of painting mine(very slow process b/c of school) and i took mine off... except parts of it were glued and it broke
so i'm gonna have to get new ones
Posted:
Mon Jan 21, 2008 6:52 pmby slm01
How much have you guys seen new ones go for, or is it worth it to pull them off a junked eg?
Posted:
Mon Jan 21, 2008 7:16 pmby sqsi
slm01 wrote:How much have you guys seen new ones go for, or is it worth it to pull them off a junked eg?
They are around $48.00 new per side
Posted:
Tue Jan 22, 2008 12:09 amby slm01
sqsi wrote:slm01 wrote:How much have you guys seen new ones go for, or is it worth it to pull them off a junked eg?
They are around $48.00 new per side
thanks