- Tue Oct 08, 2013 6:34 pm
#337426
Hello everyone.. I'm new here, but not new into hondas.
i own a 99 civic d16y8 turbo and now i'm rebuilding a 1993 eg6
i'm needing help to verify my unibody/chassis.
the car had a front/driver-side hit... i sended it to shop alignment but i want to verify if everything is fine...
i know there's a chassis measurement chart in service manual..
but im needing some advice from someone who did something like this before.. like.. where is the most important points to measure ?
the car is now into the car rotisserie and want o verify the alignment before start the rebuild.. so.. any tips to verify this chassis?
i own a 99 civic d16y8 turbo and now i'm rebuilding a 1993 eg6
i'm needing help to verify my unibody/chassis.
the car had a front/driver-side hit... i sended it to shop alignment but i want to verify if everything is fine...
i know there's a chassis measurement chart in service manual..
but im needing some advice from someone who did something like this before.. like.. where is the most important points to measure ?
the car is now into the car rotisserie and want o verify the alignment before start the rebuild.. so.. any tips to verify this chassis?