Civic EG

has any one ever done power windows in an eg hatch before ? any advice will be good

most people just wire it up i dunno how but there is a DIY on HT but if you want to have OEM setup pull the harness from a EX coupe (sedans work you just have extra wires laying around that you can cut) and just go from there

buying the doors from a ex makes it alot easier, once you put the doors on the wires from the door we'll go directly to your accesserios"spelled wrong i kno" on my ole eg they had it directly to the battery even when the car was off the windows could roll up and down

I have the same situation in my hatch, but i have conected the wires because i dont know how to do it
i try to get all the wires from an ex but i cant find one yet

buying the doors from a ex makes it alot easier, once you put the doors on the wires from the door we'll go directly to your accesserios"spelled wrong i kno" on my ole eg they had it directly to the battery even when the car was off the windows could roll up and down

how do you did it???
also i put the power locks in the car

there is alot you have to do to get power windows my boy just did it on a 4 dr and i have it done on my hatch. you have to pull off the dash,pull the whole wiring harness out from the pass. side of the engine bay it runs under the dash to the blower box and to the inside fuse box on the drivers side of the car.there is a seprate harness for 4 dr models for the rear doors. this harness is the hardest part of the whole install.the window motors and the lock solenoids are real easy.

http://civic-eg.com/viewtopic.php?t=360 ... highlight=

check this out man

i bought a power window kit and wire the new power window switchs with the door panels out of a ex. was pretty easy it took about 5 relays and a few hours of wiring to get it right but works great .