High mount brake light
Posted: Mon Nov 05, 2007 8:25 pmHi, Does any one know how to replace the high mount brake light bulb on a 94 Hatchback? Regards, Gerald.
Page 1 of 1
Posted: Mon Nov 05, 2007 8:25 pmPosted: Mon Nov 05, 2007 10:13 pmif your talking about the one in the spoiler you just take the screws out of the brake light, then you can replace the bulb
Posted: Tue Nov 06, 2007 3:45 amHi, Yes, I have gotten as far as removing the screws, but I can't see how to get the light assembly out. Gerald.
Posted: Tue Nov 06, 2007 5:37 pmit just pops out, take the wing off if it makes it easier for you.
Posted: Tue Nov 06, 2007 7:07 pmhaha i just changed my stock wing for a duck bill wing with out the light lol 
Posted: Tue Nov 06, 2007 8:01 pmits a lot easier if you just take the wing off..
Posted: Wed Nov 07, 2007 2:24 amheres my easy 4 step process man thank me later!
step 1: take off wing (4- 10 mm bolts)
step 2: install CARBON FIBER Duck Bill
step 3: Tighten those 4-10 mm nuts
Step 4 enjoy!
thank me later!
step 1: take off wing (4- 10 mm bolts)
step 2: install CARBON FIBER Duck Bill
step 3: Tighten those 4-10 mm nuts
Step 4 enjoy!
Posted: Wed Nov 07, 2007 3:07 amDC4rob wrote:heres my easy 4 step process man
step 1: take off wing (2- 10 mm bolts)
step 2: install CARBON FIBER Duck Bill
step 3: Tighten those 2-10 mm nuts
Step 4 enjoy!
Its actually 4....two on each hinge for the window.
Posted: Wed Nov 07, 2007 4:52 amEDITED! lol i forgot! hahah not use to owning a hatch anymore hahahah the teg is getting to me
Posted: Wed Nov 07, 2007 3:20 pmDC4rob wrote:heres my easy 4 step process man
step 1: take off wing (4- 10 mm bolts)
step 2: install CARBON FIBER Duck Bill
step 3: Tighten those 4-10 mm nuts
Step 4 enjoy!
very nice
Posted: Thu Nov 08, 2007 2:42 amSuccess! The problem was the gasket between the lens and housing. It was catching in the opening. I trimmed it, and now all is well. Thanks, Gerald.