What fits best, Weights & Sizes
By 88gtblack
#354995 I need about an inch. I'm thinking a 30mm will work. Someone put integra brakes on this car and my VX wheels wont clear without them.
The brakes are integra, what size is the bore so i can order hubcentric bolt on spacers that don't require extended studs. Thanks in advance.
User avatar
By Driv-it-hard
#354996 That's a really thick spacer. 30mm converts to a 1.18 inch spacer.
You would see that on rear wheel drive cars normally.
I would consider changing different wheels than putting that stress on the knuckle.

Can you post a pic ?
User avatar
By teal_dx
#355034 56.1 mm is our center bore.
Those are wide spacers but He's going the right route with hubcentric instead of the cheap ones that put all the stress on the studs :thumb: