Civic-EG.com Forum 3.3.1

- Wed May 26, 2010 5:28 pm #196938 hi all.

i have the ABS light lighting up in the gauge cluster.

when i try to get the diagnostic codes from the abs, it pops no code.
the light will just go out.

i have checked my abs sensors and they should be fine.
abs fluid is full. brakes work fine. and the abs main computer is taken out of my civic and replaced by another one. thats works correct.

the car i own is a civic EG VTEC, 1.6 16valve 92'.

can anyone help me pleas?

greetz
johan

Holland, flat country with only artificial mountains, called: speedbumps

- Sun Oct 24, 2010 1:03 pm #219711 Not sure if you fixed it or not....have you checked the service manual troubleshooting procedures? I hav the same problem on my car. Did you pull the abs test connector from the right side kick panel and use a jumper wire to get codes? It is a two pin connector. I also jumpered the 2 copper connectors after taking out the abs motor relay and my pump is either sheared or the relief valve is stuck open which makes the abs light come on. I got a used modulator unit from the junk yard and am going to install it this week I think...its a big job...and I might have to follow up at the dealer if my bleeding procedure doesn't work.

(o0)\(III)(III)/(0o)