swapping trailing arms with out the nut falling into the sub
Posted: Fri Dec 04, 2015 10:08 amhow do you swap the trailing arms with out the nut falling into the sub frame ?
Civic EG
Forum for the Honda Civic EG 1992-1995
http://civic-eg.com/forum/
swapping trailing arms with out the nut falling into the sub
Page 1 of 1
Posted: Fri Dec 04, 2015 10:08 amRe: swapping trailing arms with out the nut falling into the
Posted: Fri Dec 04, 2015 5:21 pmThe bolts that go into the chassis should have no issues with the nut popping off in the body. Never seen it happen.
Re: swapping trailing arms with out the nut falling into the
Posted: Fri Dec 04, 2015 5:35 pmIt's on a slider inside the frame. Unless you break that nut free from that adjuster, it won't fall out.
Re: swapping trailing arms with out the nut falling into the
Posted: Sun Dec 06, 2015 5:01 amThe bolt gets so rusted that it will turn the welded nut and crack the welds off. Had this happen. Take a hole saw and drill an opening up from the bottom.
Re: swapping trailing arms with out the nut falling into the
Posted: Thu Feb 04, 2016 12:54 amso i figured out the answer and you have 2 choices
A. reuse the old rr comp arm i.e., don't unbolt it
B. stick a screw driver in the hole to make sure the nut stays in place when you unbolt the old rr comp arm
going to pick up si trailing arms this weekend and am probably going to go with option A
A. reuse the old rr comp arm i.e., don't unbolt it
B. stick a screw driver in the hole to make sure the nut stays in place when you unbolt the old rr comp arm
going to pick up si trailing arms this weekend and am probably going to go with option A