Civic-EG.com Forum 3.3.1

- Fri Mar 20, 2015 12:46 am #352718 I have finally started to get an idea of where I need to start with this project car...

Current issues:
1) drivers side Axle rubbing on strut fork.. Innovative mounts (at least what I think they are) h22 swap btw

2) Steering and alignment completely out of wack

Took both wheels off and this is what it looks like:

Drivers side









Passenger side:





What are all the parts you guys see that need to be replaced?

[teal_dx]

- Fri Mar 20, 2015 3:50 am #352722 I see a couple of the upper/lower balljoint dust covers look to be torn/letting a little grease out, but nothing major.
Steering boot is completely torn on the end. Replace that for sure.
The boot on the tie rod end link has a good size rip, I'd replace that while I have things apart and before getting the car aligned.

Really, it's about how the car feels. If it's sloppy and making clunk/knock sounds from the front end, then you need to isolate & figure out which joint it is. Upper ball joints seem to be the first to go.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage