Skunk 2 pro-c
Posted: Sat Apr 14, 2012 3:01 amI recently purchased these and for some reason I can't get the fork screw to line back up. The 14mm bolt on top that connects to the coil over. Has anyone else had this problem? Please help
Page 1 of 1
Posted: Sat Apr 14, 2012 3:01 amPosted: Sat Apr 14, 2012 3:56 amwhat exact bolt are you talking about?
Posted: Sat Apr 14, 2012 6:06 amOn the rear lower control arms, you have to load the suspension a bit to get them to go on. and are you sure your bushing is not knocked out of wack?
Re: Skunk 2 pro-c
Posted: Sat Apr 14, 2012 6:23 amillason wrote:I recently purchased these and for some reason I can't get the fork screw to line back up. The 14mm bolt on top that connects to the coil over. Has anyone else had this problem? Please help
maybe try jacking up the brake disc... or put the bolt through the fork before the coilovers
Posted: Sat Apr 14, 2012 6:24 ami've had this problem a few times....but not anymore....
is it the rear or the front?
is it the rear or the front?
Posted: Sat Apr 14, 2012 10:10 amI'm talking about the front fork. You have the coil over, then you need the oem fork that attaches to the coil over with a 14 mm bolt. The diameter of the new pro c seems to be too large for the oem fork. Is there a trick or solution for this problem?
Posted: Sat Apr 14, 2012 2:39 pmi know exactly what your tqlking about now. I had a similair problem with my skunk2 struts. you may have to ream it out ever so slightly with a drill bit or something like that. and u may also have to put it in a vise and gently clamp it just enough to get the bolt to line up right with the threads
Posted: Sat Apr 14, 2012 5:31 pmillason wrote:I'm talking about the front fork. You have the coil over, then you need the oem fork that attaches to the coil over with a 14 mm bolt. The diameter of the new pro c seems to be too large for the oem fork. Is there a trick or solution for this problem?
maybe try hammering it through and wd40....