Civic-EG.com Forum 3.3.1

- Sat Mar 10, 2012 1:30 pm #297701

i Know its blurry but thats the front LCA where it connects to the spindle , my problem is i cant get the lca off from there i got it off from the subframe but now it wont drop from there if it jiggle it the bolt juts moves with it ,is there anything i can do to get it off

- Sat Mar 10, 2012 3:58 pm #297711 you need a ball joint separating tool.


or you can do it with a big flathead but your likely to rear the boot

Last edited by TrailerTrash on Sat Mar 10, 2012 6:24 pm, edited 1 time in total.

95 Civic Coupe DX - d15b7 - some mods nothing crazy - My 5th EG
98 Jeep Cherokee 2 door - little lift with 31s 4.0 5 speed
77 Chevrolet C10 - Mild 350/350 combo - lowered a little

- Sat Mar 10, 2012 6:18 pm #297726

you need a ball joint separating tool.

Yes, this. You can rent one from Autozone.

- Sat Mar 10, 2012 8:19 pm #297744 Try this too if you haven't. Hope you get it off.

http://www.youtube.com/watch?v=ISY8bGof3bQ&feature=fvst

- Sat Mar 10, 2012 9:20 pm #297750

Try this too if you haven't. Hope you get it off.

http://www.youtube.com/watch?v=ISY8bGof3bQ&feature=fvst

neato

95 Civic Coupe DX - d15b7 - some mods nothing crazy - My 5th EG
98 Jeep Cherokee 2 door - little lift with 31s 4.0 5 speed
77 Chevrolet C10 - Mild 350/350 combo - lowered a little

- Sun Mar 11, 2012 2:06 am #297786 I know huh...I did this when I had to change my ball joints..

- Mon Mar 12, 2012 5:51 pm #297931 hit it with a hammer. perferably a big one. dont hit the ball joint or the thread. hit what it gose through