Civic-EG.com Forum 3.3.1

- Mon Oct 03, 2011 2:02 am #275852 ok guys i have a bad wheel bearing on my passanger side the hub is also shot witch fucks up the wheel bearings. my buddy gave me the whole driver side spindle off his old hatch would this work on my passanger side ? or will the brake calliper not match up ? help if u can

- Mon Oct 03, 2011 2:13 am #275855 depends on the models of the two hatches if its a SI it will have the bigger rotor and brake set up the others are all the same with the smaller brake setup and will be a direct swap with out any issues.

95 EJ1 BG33P - RC
95 EJ2 BG33P - DRC

Coupe Crew #20

- Mon Oct 03, 2011 2:14 am #275856 wont work. the tie rod end mounting wont be on the correct side of the spindle. or the brake caliper and lines.

Coupe Crew #16
DC2: http://www.civic-eg.com/viewtopic.php?t=21051

- Mon Oct 03, 2011 2:25 am #275862 man I must be really tired not to read that right RWMIII is right it won't work you could remove the hub from that spindle and put into yours and fix it but no way you can put a drivers side on the passenger side

95 EJ1 BG33P - RC
95 EJ2 BG33P - DRC

Coupe Crew #20

- Wed Oct 05, 2011 5:17 am #276293

wont work. the tie rod end mounting wont be on the correct side of the spindle. or the brake caliper and lines.

true