Civic-EG.com Forum 3.3.1

- Tue Sep 13, 2011 3:40 am #271657 My CX has no mounts for a front sway bar. Which OE lower control arms can I use? 92-95 Civic or 94-01 Integra? Or can I use both? Its just a bummer cause I spent two weekends pressing in all the poly bushings! O well. Any advice?

1994 Civic CX B16A...Who needs A/C or Powersteering anyways?

- Tue Sep 13, 2011 3:57 am #271661 either will work. DC2 or EG.

- Wed Sep 14, 2011 10:00 am #271902 Even DA front control arms should be the same as the EG and DC2.

95 EJ1 BG33P - RC
95 EJ2 BG33P - DRC

Coupe Crew #20

- Wed Sep 14, 2011 6:39 pm #271978

Even DA front control arms should be the same as the EG and DC2.

edit: misread post. Front lowers are not compatible, however the rear lowers are

Last edited by RWMIII on Thu Sep 15, 2011 10:50 pm, edited 1 time in total.

- Wed Sep 14, 2011 8:46 pm #272009 http://www.am-autoparts.com/1992/Honda/ ... 51502.html

- Thu Sep 15, 2011 5:43 pm #272180

Even DA front control arms should be the same as the EG and DC2.

x2

They're not even similar.

DA



EG/DC (EK are simliar, not sure if compatible)


[/img]

- Thu Sep 15, 2011 10:49 pm #272214 Good for you

I misread the post. The rears are compatible, not the fronts.

- Fri Sep 16, 2011 4:09 am #272285 civic LX, EX, Si 92-95 or any 94+ integra's will work.

92 civic cx sold!!
horizon gray 94 LX-A wrecked :/
white 92 civic Si (traded)
primered 94 teg sold
92 civic DX sold!!
93 red EX coupe parted out!
93 LS400 Midnight indigo sold!
92 civic LX sold!!
90 240sx sold!
93 faded black EX coupe

- Fri Sep 16, 2011 9:11 am #272313 My bad I forgot DA run a torsion bar up front. But EK should be the same as EG/DC, tend not to see that many DA running around anymore.

95 EJ1 BG33P - RC
95 EJ2 BG33P - DRC

Coupe Crew #20

- Fri Sep 16, 2011 3:37 pm #272328

http://www.am-autoparts.com/1992/Honda/Civic/ControlArmsFront/AM-30497104/351502.html

Its right here
Just get these