Page 1 of 1
I just bought OEM springs which go in the front and rear?

Posted:
Fri Apr 23, 2010 6:38 am
by Jailbreak Ryan
I just bought some OEM springs because the previous ones were not only cut they were Ebay springs. They're in fairly good condition for being on a 93 Coupe. There isn't much difference in them besides the one of the right is is a little thinner than the left. Could you help me out here? Also that isn't rust it's just dirt. I started cleaning them and they're looking much better.


Posted:
Fri Apr 23, 2010 12:44 pm
by country_civic
dude you need to read the noob section and rules and guidelines page on pics this pic is f-ing huge man read up and learn whats going on

Posted:
Fri Apr 23, 2010 7:48 pm
by egsedanguy
hey now the pic is fine. i would rather see it then need a damn magnifying glass.
and for ur question im not sure cause from the pic they look the same. but the rear should have a smaller coil that sits on the shock purch.

Posted:
Fri Apr 23, 2010 7:49 pm
by egsedanguy
actually i think the one on the left is for the rear...


Posted:
Fri Apr 23, 2010 9:51 pm
by Jailbreak Ryan
Here is another pic.


Posted:
Fri Apr 23, 2010 10:19 pm
by Classiccarsrule85
well i can tell mainly by this....
take one of each and press down on them the softer one is for the back and the stiffer one up from as it holds the engine ect.....thats how i did mine up....
p.s. that is a tiny keyboard lol

Posted:
Sat Apr 24, 2010 4:57 am
by chrono404
Front Springs will be thicker then the rear ones.

Posted:
Sat Apr 24, 2010 5:38 am
by asianrob
looks like the 2 middle ones are fronts .. the fronts if i remember right have smaller coils going towards the bottom.