- Sun Jun 22, 2008 11:20 am
#59316
Hi all,
Since I purchased my Civic HB a few months ago I always knew it had a kill switch, but it never seemed to work correctly. It would stop the engine from starting but would continuously flash all four corners.
So today I thought I'd see if I could disconnect it in preparation to install a full alarm system I'm looking at purchasing.
Anyway, I ended up finding that it already has an unknown alarm wired up, however I have no control for it.
Simply unplugging it is no good either as doing this also cuts the engine.
Does anyone have any idea where I could start removing this from?
The only thing that could make sense is some text on the circuit board "SERIE 80 ALARM"
Since I purchased my Civic HB a few months ago I always knew it had a kill switch, but it never seemed to work correctly. It would stop the engine from starting but would continuously flash all four corners.
So today I thought I'd see if I could disconnect it in preparation to install a full alarm system I'm looking at purchasing.
Anyway, I ended up finding that it already has an unknown alarm wired up, however I have no control for it.
Simply unplugging it is no good either as doing this also cuts the engine.
Does anyone have any idea where I could start removing this from?
The only thing that could make sense is some text on the circuit board "SERIE 80 ALARM"