Page 1 of 1
Cut-off AEM EMS S1
Posted:
Tue Mar 21, 2017 7:27 pm
by Diego
Dear good evening
I have a AEM EMS S1 installed on my civic EG6 B16 engine, but after I turn on O2 feedback, cut off don’t work more.
How can I do configure the options of the O2 feedback for continue to have cut off in decelerations?
Waiting returns, thanks.
Re: Cut-off AEM EMS S1
Posted:
Wed Mar 22, 2017 2:18 am
by suspendedHatch
Decel fuel cut off?
What are the conditional settings for DFCO?
Actually, just ask on the aempower forums. I haven't had the EMS since mine failed back in 2009 or 10.
Re: Cut-off AEM EMS S1
Posted:
Wed Mar 22, 2017 12:58 pm
by Diego
Good morning
I dont found the parameter DFCO, where are its?
Folow the informations below:
O2 FB Control = check
O2 FB + limit = +10%
O2 FB - limit = - 10%
O2 FBGain = 1
O2 FB Coolant = 50 °C
o2 FB max = 5000 rpm
O2 FB min = 500 rpm
Accel O2 FB inhibit = 196 mS
Decel O2 FB inhibit = 196 mS
Accel fuel load = 85 kPa
Thanks
Re: Cut-off AEM EMS S1
Posted:
Thu Mar 23, 2017 2:01 am
by Diego
I changed the tps for 4% and the cut-off start work again.
Now I need to adjust the idle, when cold engine, afr its fine,about 0,96 ~1, but when heat engine, the afr is much rich, 0,86 at idle.
How do i can to correct this?
Thanks