Civic-EG.com Forum 3.3.1

- Thu Jan 22, 2015 9:47 pm #351246 hi all,

I have problem with my turn lights, more exactly it's rear passenger side blinker - it doesnt work, this blinker works only if i turn on hazard(backup)
lights. Front same side turn signal blinks fast...

I added extra ground wire next to car body and blinker ground cable
Tryed diffrent bulbs too
Checked turn signals lever , even changed to another one, result same

what else to check? where to look for problem

- Mon Feb 09, 2015 6:16 pm #351735 check the sockets that the bulbs sit in for corrosion.

- Wed Feb 11, 2015 11:58 pm #351793

hi all,

I have problem with my turn lights, more exactly it's rear passenger side blinker - it doesnt work, this blinker works only if i turn on hazard(backup)
lights. Front same side turn signal blinks fast...

I added extra ground wire next to car body and blinker ground cable
Tryed diffrent bulbs too
Checked turn signals lever , even changed to another one, result same

what else to check? where to look for problem

any word on how this went because I'm having a similar problem but my turn signal in front comes on but the side marker and the rear don't it just keeps blinking rapidly....

- Mon Feb 16, 2015 10:34 pm #351942

hi all,

I have problem with my turn lights, more exactly it's rear passenger side blinker - it doesnt work, this blinker works only if i turn on hazard(backup)
lights. Front same side turn signal blinks fast...

I added extra ground wire next to car body and blinker ground cable
Tryed diffrent bulbs too
Checked turn signals lever , even changed to another one, result same

what else to check? where to look for problem

any word on how this went because I'm having a similar problem but my turn signal in front comes on but the side marker and the rear don't it just keeps blinking rapidly....

i had this same issue, here is what to try:
1. check if you have any blown bulbs if so change them.
2. remove the bulbs and use sand paper or anything rigid to remove any corrosion that is on the bulb then clean up in the socket with the sandpaper.