- Sat Nov 09, 2013 11:16 pm
#338583
finished up my full tuck on this car like nearly a year ago now, after tuck was done, turn signals and hazards worked fine.
now after driving around(car sat for a year lol) turn signals worked for the first 15 minutes of my drive, fuse blew.
replaced fuse, all worked except drivers front when i hit the hazard switch. turn signal arm wont work at all. fuse blew.
replaced fuse, rear drivers works, front does not. passenger does not work at all. fuse blew again.
basically i know i did something wrong with my tuck, prolly mixed up a wire or two.
is there anyway i can repair this by installing my own switch/s for my turn signals withouth having to tear back into my harness? im thinking of wiring them into my trunk deck center lights and run them from my fog lights up front instead of the corner lights and wire them to be on all time for running lights.
good idea? bad idea? how would i go about doing this?
i really dont want to tear apart my harness looms and trace back through 29034729390273 wires.
now after driving around(car sat for a year lol) turn signals worked for the first 15 minutes of my drive, fuse blew.
replaced fuse, all worked except drivers front when i hit the hazard switch. turn signal arm wont work at all. fuse blew.
replaced fuse, rear drivers works, front does not. passenger does not work at all. fuse blew again.
basically i know i did something wrong with my tuck, prolly mixed up a wire or two.
is there anyway i can repair this by installing my own switch/s for my turn signals withouth having to tear back into my harness? im thinking of wiring them into my trunk deck center lights and run them from my fog lights up front instead of the corner lights and wire them to be on all time for running lights.
good idea? bad idea? how would i go about doing this?
i really dont want to tear apart my harness looms and trace back through 29034729390273 wires.
-'93 coupe