Help Me Clarify CEL Code

ECU, Wiring, Sensors
 Reply
User avatar

Help Me Clarify CEL Code

By Skillachie
- Thu Jan 10, 2013 8:38 pm #323747 Could someone clarify this for me, its a 92 EG Hatch with a full LS Swap in it and i just picked it up about a month ago. I got it with the check engine light on and a high idle.
Any hows the engine idles high all the time and i want it to go to normal mode lol, i figure i'd see what the cel light says but cant seem to read the code properly, i read a 9 but i dont see a cel code for 9

http://www.youtube.com/watch?v=Mlp6FCDt00U

This i've done so far;
Clean IAC Valve with carb cleaner
Check for air leaks with said carb cleaner
Check coolant
User avatar

By Eg6H2D
- Thu Jan 10, 2013 9:07 pm #323752 The ECU codes are at the top of the Electrical forum. u need to Search before assuming bud...

Click here first..

http://civic-eg.com/viewforum.php?f=12

and then here..

http://civic-eg.com/viewtopic.php?t=1558

It's Actually a Sticky so it will always be at the top of the Thread.

So im seeing CYP as code nine? If im not mistake that's the sensor inside the Distributor or attached to it. What year is the engine and what ECU does the car have?

We Need DETAILS in order to help.


1 O2A - Oxygen sensor #1
2 O2B - Oxygen sensor #2
3 MAP - manifold absolute pressure sensor
4 CKP - crank position sensor
5 MAP - manifold absolute pressure sensor
6 ECT - water temperature sensor
7 TPS - throttle position sensor
8 TDC - top dead centre sensor
9 CYP - cylinder sensor
10 IAT - intake air temperature sensor
12 EGR - exhaust gas recirculation lift valve
13 BARO - atmospheric pressure sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
16 Fuel injectors
17 VSS - speed sensor
19 Automatic transmission lockup control valve
20 Electrical load detector
21 VTEC spool solenoid valve
22 VTEC pressure valve
23 Knock sensor
30 Automatic transmission A signal
31 Automatic transmission B signal
36 traction control found on JDM ecu's
41 Primary oxygen sensor heater
43 Fuel supply system
45 Fuel system too rich or lean
48 LAF - lean air fuel sensor
54 CKF - crank fluctuation sensor
58 TDC sensor #2
61 Primary oxygen sensor
63 Secondary oxygen sensor
65 Secondary oxygen sensor heater
71 random misfire cylinder 1
72 random misfire cylinder 2
73 random misfire cylinder 3
74 random misfire cylinder 4
80 Exhaust Gas Recirculation insufficient flow detected
86 ECT Sensor (Engine Coolant Temperature) circuit range / performance problem
90 Evaporative Emission Control System leak detected in the fuel tank area
91 Fuel Tank Pressure Sensor low input
92 Evaporative Emission Control System insufficient purge flow
User avatar

By Skillachie
- Thu Jan 10, 2013 9:29 pm #323761
Eg6H2D wrote:The ECU codes are at the top of the Electrical forum. u need to Search before assuming bud...

Click here first..

http://civic-eg.com/viewforum.php?f=12

and then here..

http://civic-eg.com/viewtopic.php?t=1558

It's Actually a Sticky so it will always be at the top of the Thread.

So im seeing CYP as code nine? If im not mistake that's the sensor inside the Distributor or attached to it. What year is the engine and what ECU does the car have?

We Need DETAILS in order to help.


1 O2A - Oxygen sensor #1
2 O2B - Oxygen sensor #2
3 MAP - manifold absolute pressure sensor
4 CKP - crank position sensor
5 MAP - manifold absolute pressure sensor
6 ECT - water temperature sensor
7 TPS - throttle position sensor
8 TDC - top dead centre sensor
9 CYP - cylinder sensor
10 IAT - intake air temperature sensor
12 EGR - exhaust gas recirculation lift valve
13 BARO - atmospheric pressure sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
16 Fuel injectors
17 VSS - speed sensor
19 Automatic transmission lockup control valve
20 Electrical load detector
21 VTEC spool solenoid valve
22 VTEC pressure valve
23 Knock sensor
30 Automatic transmission A signal
31 Automatic transmission B signal
36 traction control found on JDM ecu's
41 Primary oxygen sensor heater
43 Fuel supply system
45 Fuel system too rich or lean
48 LAF - lean air fuel sensor
54 CKF - crank fluctuation sensor
58 TDC sensor #2
61 Primary oxygen sensor
63 Secondary oxygen sensor
65 Secondary oxygen sensor heater
71 random misfire cylinder 1
72 random misfire cylinder 2
73 random misfire cylinder 3
74 random misfire cylinder 4
80 Exhaust Gas Recirculation insufficient flow detected
86 ECT Sensor (Engine Coolant Temperature) circuit range / performance problem
90 Evaporative Emission Control System leak detected in the fuel tank area
91 Fuel Tank Pressure Sensor low input
92 Evaporative Emission Control System insufficient purge flow


Its a 96 LS with 37820-PR4-L11 for the ECU not sure what kind of ECU it is :?
I thought that becus it was a OBD2 engine it would be a OBD2 code
and i swore i looked at the ECU thread and didnt see anything below 10 :headscratch:
It was prob late [smilie=notworthy.gif] Ma bad
Last edited by Skillachie on Thu Jan 10, 2013 11:44 pm, edited 2 times in total.
User avatar

By Skillachie
- Thu Jan 10, 2013 9:38 pm #323767
JUICE wrote:http://www.team-integra.net/forum/11-generation-three/51441-cel-4-ckp-cel-8-tdc-cel-9-cyp.html


Thanks for the link juice very informative :thumb:


So did a quick search and my ECU might be

37820PR4L11 INTEGRA 92-93 Elec Cont Unit (ECU)
Last edited by Skillachie on Thu Jan 10, 2013 11:01 pm, edited 1 time in total.
User avatar

By Skillachie
- Thu Jan 10, 2013 10:56 pm #323776 Its the
37820-PR4-L11

But the previous owner told me it was a 96 Integra LS swap, but i checked online and that ECU is from a 92-93 Integra :x

Could it be that the ECU is causing My high idle and check engine light?

I guess my next step is to check if i have a 92-93 Engine or 96 Engine with a 92-93 ECU :bs: [smilie=BangHead.gif]
User avatar

By Skillachie
- Fri Jan 11, 2013 12:30 pm #323846 Well quick update THEY STOLE MY CAR :x
No needing this fix anymore
User avatar

By Skillachie
- Fri Jan 11, 2013 9:18 pm #323872 Yeah man, thank!
Definitely hurts! :x
User avatar

By brandoff88
- Fri Jan 11, 2013 9:45 pm #323874 do you think the guy kept an extra key and came and took it back or something? i know that happens sometimes...but seriously man i feel for ya...i have had so much shit stollen from me, game systems, someone even stole my homemade bong made out of a long island ice tea cup with a pen as the stem and a socket from a ratchet set as a bowl lol...i was like wtf, its not what it was worth that counts but the fact that someone took your shit, luckily i live where there are a few car thefts but its just dumb kids that party and joyride, not chop em up...but i wish you luck man, did you have insurance on it?
User avatar

By Skillachie
- Fri Jan 11, 2013 10:02 pm #323877 It couldve been the guy who sold me the sold, but who knows right.
I have insurance just not the kind to pay back for my car :cry:
The cop do have a video of my car leaving the complex though with another car on its ass out the gate!
I'll just let them do their job and hopefully find it!
User avatar

By brandoff88
- Fri Jan 11, 2013 10:19 pm #323883 hey at least they are doing something about it lol, most big cities wont do shit if a car let alone a HONDA is stolen good luck bro i hope all turns out well for you
 Reply
Return to Chassis - Electrical