- Mon Apr 30, 2012 5:17 pm
#303382
hey guys, just attempted to convert my ecu by following the write up here. removed the 2 resistors and put in the jumper wire. isntalled and also tryed to delete my code ( pulled 7.5 backup fuse for 30 mins)
but im still getting my code 19 for my auto. how do i get rid of the code withought buying a new ecu.
when i desolderderd the resistors and installed my jumper i checked for resistance at my 2 points. the desolderd and removed resistor had no resistance at both 2 points on the circuit board. and my jumper wire showed resistance meaning my 2 points where making good contact.
any help ?
but im still getting my code 19 for my auto. how do i get rid of the code withought buying a new ecu.
when i desolderderd the resistors and installed my jumper i checked for resistance at my 2 points. the desolderd and removed resistor had no resistance at both 2 points on the circuit board. and my jumper wire showed resistance meaning my 2 points where making good contact.
any help ?