Civic EG

Posted: **Wed Sep 07, 2011 3:28 am**

kapow wrote:Can you please upload OBD2A codes, i'm using a newer ecu

Check here: http://www.civic-eg.com/viewtopic.php?p=270688#270688

Posted: **Wed Sep 07, 2011 3:30 am**

EGg OH! wrote:My car is throwing three codes. The one I'm a bit curious about is the first, It's simply one long flash then it goes on to the other codes, is this a 1 or 10?
I just want to be sure, there's quite big difference between an O2 sensor and an Intake Air Temp sensor.

It is a 10 since it is one long flash, if it were just a short one then it would be a 1. It is the lowest number on the totem pole, thats why it is first. The codes will be shown in sequential number order. :thumb:

edit:fixed typo

Posted: **Wed Sep 07, 2011 3:43 am**

RWMIII wrote:
EGg OH! wrote:My car is throwing three codes. The one I'm a bit curious about is the first, It's simply one long flash then it goes on to the other codes, is this a 1 or 10?
I just want to be sure, there's quite big difference between an O2 sensor and an Intake Air Temp sensor.

one long flash = 10

Posted: **Fri Oct 28, 2011 12:28 am**

i have been having a problem with my hatch, it doesnt happen all the time but when i try to take off i give it gas and it starts to bog down and sputters. i checked for codes and not sure if it is a code 1 and 10 or or. i get one long flash 5 sec then one short flash. then it starts over again with 5 sec between everytime.

Posted: **Thu Apr 26, 2012 1:23 am**

Ok I know this is an old post but I can't take it anymore. I have a 92 si and can't find the cel plug anywhere. It is def. not where the ecu is & I don't see it anywhere. Anyone have any advice, it would be greatly appreciated. My cel came on once awhile ago when I ran it low on oil & went into vtec. It wasn't on the next time I started the car, do P28's store codes? Thanks guys.

Posted: **Wed May 02, 2012 12:36 am**

Anyone? Lol...

Posted: **Mon Jul 23, 2012 1:36 am**

My 95 lx eg8 d15b7 auto.. The check engine light only comes on when i go 70 to 80 and faster. Then i shut it off. Jump the two wiers and no cel light comes on, just when frist turning the key to on. Then after that i would drive it right to get good gas mileg. And no cel light would come on.
One thing to Note is i just started having a hard time starting my car. bad connection. The battery is in the trunk but its been in the trunk for over a couple years.

And sometimes the idel jumps up and down gast

Any help plz. Thanks.. [/img]

Posted: **Wed Nov 28, 2012 3:27 am**

I started following this guide and I got confused because I was getting more than one set of blinks. Can someone help me out? I'll post a link below of what I'm getting.

P.s. please ignore the people talking!

http://m.youtube.com/watch?v=JJ5D1PLK0ds

Posted: **Wed Nov 28, 2012 5:53 am**

JohnRM wrote:I started following this guide and I got confused because I was getting more than one set of blinks. Can someone help me out? I'll post a link below of what I'm getting.

P.s. please ignore the people talking!

http://m.youtube.com/watch?v=JJ5D1PLK0ds

You have codes 9 and 17 which is cylinder sensor and VSS speed sensor

Posted: **Thu Nov 29, 2012 2:16 am**

Thanks for the reply! I understand how to read the CEL now.

Civic EG

ECU codes and CEL diagnosis

CEL Plug

Check engine light only comes on when would