Page 1 of 1
Indicators and brack lights stoped working.. help !!!!
Posted:
Tue Apr 13, 2010 2:43 pmby TENGOKU25
so yer i not long ago installed sum diy white face dials on my project ej2 coupe and i just got round to geting sum petrol and geting sum power back in the battery so i could try them out but as i was haveing a check over i found the indicators and brack lights not working . there was not even the ticking sound when i put them on nore was the lights on the dash flashing but thay worked when i put the hazards on apart from only 1 of the indicator lights did not flash. i checked the indicator fuse and thats ok but i have not checked the brake light fuse yet but im shor its not thos fuses...could anuffer fuse have gone sum were when i jump started the car ?
Posted:
Tue Apr 13, 2010 5:57 pmby teal_dx
I have never had a fuse blow when jumping the battery. But double check all your fuses. is it possible you may have left some wiring exposed when you had the dash apart, causing a short?
Posted:
Tue Apr 13, 2010 6:59 pmby TENGOKU25
its all good naw all it needed was a nice wack to the lights and a little wigle to sum of the wires
yay
Posted:
Tue Apr 13, 2010 7:51 pmby egsedanguy
TENGOKU25 wrote:its all good naw all it needed was a nice wack to the lights and a little wigle to sum of the wires yay
dude thats no good. that means you got a bad wire somewere. hopfully its not exposed and start a dash fire...
Posted:
Tue Apr 13, 2010 8:01 pmby TENGOKU25
oo crap never thort of that ill give it a good look over tomorow ... with my brake light i have to hit it sumtimes to get it working what do you think it is a loss wire or sum fing
Posted:
Tue Apr 13, 2010 8:06 pmby egsedanguy
TENGOKU25 wrote:oo crap never thort of that ill give it a good look over tomorow ... with my brake light i have to hit it sumtimes to get it working what do you think it is a loss wire or sum fing
well it proly a lose ground somwere. do u have an aftermarket alarm in it? if so check all the splices were it wired into your harness and make sure its all good. also check for cut wires.
Posted:
Tue Apr 13, 2010 8:26 pmby TENGOKU25
na its all standed. when i moved sum of the wires to try and get it i moved thos 2 that go in the back of the cluster