Page 1 of 1

News! Re-Release of Vibrant Tri Y Header H22!!!!

PostPosted: Thu Aug 11, 2011 8:43 pm
by Eg6H2D

PostPosted: Sat Aug 13, 2011 8:44 pm
by kross
but will this work with a EG swap without custom fabbing?

PostPosted: Sat Aug 13, 2011 9:53 pm
by jigga36
^x2

PostPosted: Sun Aug 14, 2011 2:05 am
by RWMIII
kross wrote:but will this work with a EG swap without custom fabbing?


I'm guessing the design is a happy medium for all the cars that you can swap an H series into. Looking at it again I think it would be just fine if you were to connect straight tubing to it all the way back, it just won't be perfectly on center


This is what the vendor says about it :thumb:

PostPosted: Sun Aug 14, 2011 2:55 am
by kross
sorry if i dont understand it, as im actually looking into a new header anyways. my cheap dc replica is all beat up from being WAY too low lol

PostPosted: Sun Aug 14, 2011 4:47 pm
by Eg6H2D
RWMIII wrote:
kross wrote:but will this work with a EG swap without custom fabbing?


I'm guessing the design is a happy medium for all the cars that you can swap an H series into. Looking at it again I think it would be just fine if you were to connect straight tubing to it all the way back, it just won't be perfectly on center


This is what the vendor says about it :thumb:


:thumb:

when custom making swap as in H2b and H2d you always have to make things work.. regullar full H swap into eg it should work. just might have to mod the exhaust a little bit. that's all.