Civic EG

Posted: **Tue Apr 26, 2011 5:26 pm**

i am running a po6 ecu in my h22 swap. does anybody kno what car this is from. i read where ppl say you cant use it b/c it doesnt have vtech but mine kicks in hard at lik 5400 rpms

Posted: **Tue Apr 26, 2011 5:56 pm**

Po6 is a stock dx ecu. Unless its been chipped and converted it won't have vtec

Posted: **Tue Apr 26, 2011 6:30 pm**

well i bought the whole swap including the ecu from sombody. does this means they had it chipped?

Posted: **Tue Apr 26, 2011 8:50 pm**

Because it came wityh it doesnt mean its set up for it. Was it running before you bought the engine. It might be chipped to run the motor. or it might now. if it's not then i suggest you find a ECU chipper and get it chipped for the engine or it's not going to run properly..

:thumb:

Posted: **Tue Apr 26, 2011 9:53 pm**

Open the ecu its only 5 screws and take a pic put it on here and I can tell you weather it chipped or not :thumb:

Posted: **Wed Apr 27, 2011 5:41 am**

if you motor runs with no probs its not a stock p06....ive ran a h22 on a p06....noooooooooooooooooo low end and will throw cel's

Posted: **Thu Apr 28, 2011 2:47 am**

mooze wrote:if you motor runs with no probs its not a stock p06....ive ran a h22 on a p06....noooooooooooooooooo low end and will throw cel's

This is verrrrrry true tried running a ls on a po6 barely pulled out of its own way

Posted: **Thu Apr 28, 2011 10:49 pm**

ok my brother is a dumby he told me it was a p06 ecu when in fact it as an p0f srry for the mix up but i read tht this is off an accord SiR does anybody kno anythng else about this ecu lik rev or speed limiter

Posted: **Thu Apr 28, 2011 11:23 pm**

I'm not going to bs you thats a jdm ecu and I've never had the cover off of one but it dosent looked chipped to me (I see a 28 pin chip there but Idk if a jdm ecu has something like that factory or not) but if it is it dosent have a data log port, but anyway if its the accord sir ecu it probably will serve you just fine

Posted: **Thu Apr 28, 2011 11:26 pm**

aliright kool

Posted: **Fri Apr 29, 2011 1:02 am**

Yes if it's the Accord Sir Ecu if it's not auto then your good for now..

Posted: **Fri Apr 29, 2011 1:21 am**

thnx for the help

Posted: **Mon Jun 13, 2011 7:14 pm**

Please forgive me, I'm a noob. I have a P05 ecu, this will not work for an H22 swap ... right?

[img][img]http://i1179.photobucket.com/albums/x398/dirtonaboi/1478d3b5.jpg[/img][/img]

Posted: **Tue Jun 14, 2011 5:52 pm**

Found this bad boy in the scrap yard today!!!

[img][img]http://i1179.photobucket.com/albums/x398/dirtonaboi/ff08ffa8.jpg[/img][/img]

Posted: **Tue Jun 21, 2011 7:06 pm**

to EG6b20R
i just noticed you said for now... y does somthng go rong

Civic EG

ecu help

ecu help