Civic-EG.com Forum 3.3.1

- Sat Jan 30, 2010 1:42 am #171997 does anyone else on here have a h2b kit. im looking to borrow or get some specs on the block template used to grind off the rear of the block to make the driver side axle fit. i have the new swap ready to go in and dont have my template from the original block so....

#9 Member of CHANCE is HOMO club

- Sun Jan 31, 2010 2:43 am #172279 http://www.quartersportsdrag.com/Kit_Contents.html
and evolutions kit
http://www.honda-tech.com/showthread.php?t=2504490

if you just need to grind the block. why dont you just line everything up then grind it. i herd its just on the backside of the block to line a mount up.

- Sun Jan 31, 2010 3:09 am #172285 on the back side so axle can clear. jut grind down the back side of block near the tranny until can get the axle in and turn it with your hand without it getting caught on anything

- Sun Jan 31, 2010 4:34 am #172304 yeah i know what and where the material needs to be removed but im just a little sceptical about doing it free hand and cuttin to deep then i got some f-ed up shit. i dont know though i called evolution industries they are gona send me one so they say should take about a week to get here any longer than that and i might just free hand it

#9 Member of CHANCE is HOMO club